Loading... Please wait...

Instructions

Instructions for use:


Insert hand under fixed arm support between the two metal bars. Grasp EZ Hang handle firmly.

Loading: Push release button on reel with back of middle finger of grip hand and center weight in the middle of the pouch, pinching the ends of the pouch over weight, using thumb and index finger of right hand.


Stance: Point your left foot and shoulder directly at the target, while turning body to the right. Distribute weight evenly on both feet, spacing approximately shoulder length apart. Turn head directly towards target.

Aiming: Use top prong of yoke as aiming reference. Move yoke up or down adjusting for distance.

Drawing Bands: Hold left arm straight with elbow locked, Yoke should be facing in the 2:00 O'clock position, while holding weight pouch firmly between thumb and index finger in right hand., draw bands straight back to your chest.( THERE SHOULD BE NO SLACK IN LINE )
Firing and Follow Through: Release pouch to shoot. Hold position until weight has left the pouch. Watch where shot lands.

Winding Back: Disconnect weight from snap always, tie loop in intermediate line or string ( 30 LB test or higher ). Reel intermediate line over tree or object. Attached antenna rope to twine and pull rope over tree or object.

If Line gets stuck in tree, do not pull hard, it will fly right back at you. Always wear protective eye and Head wear. Cut line, tie a new clip & weight on and try again.

This is a two step process.


NEVER ATTEMPT TO REEL WEIGHT BACK THROUGH TREE !

NEVER ATTEMPT TO PULL BACK YOUR ROPE WITH THE EZ HANG !


NOTE

Instructions are for right-handed people. Reverse hands and stance for left handed people

EZ HANG CARE

Always check bands prior to shooting for signs of damage or wear. For best results, store EZ HANG away from sunlight, automobile exhaust and gas heaters. Always use EZ HANG WEIGHTS DESIGNED FOR EZ HANG TOOL. Other weights will cause damage to Bands !

CAUTION: Never draw bands back to your eye. Serious injury can result. Always wear protective head & eye gear.

Never Shoot EZ HANG over power lines or electrical cables.


Line Replacement

 

Twist off the front cover counter clockwise 1/4 turn and pull the cover straight off. Then turn off the spinner head, now you can see the spool, take off any old line left on the spool. Feed the new line through the front cover and Tie on the new line to the spool. Put the spinner head back on and front cover. Then crank the new line on 300'. Make sure the natural curl of the new line is wound on the same direction to your spool. EZ Hang also sells a pre-wound spool from the factory with 10ld test 300' ( on our web site www.ezhang.com under replacement parts) so you can replace your old one if you like.

 

Spool Replacement

Twist off the front cover counter clockwise 1/4 turn and pull the cover straight off. Then turn off the spinner head, now you can see the spool, remove E-Clip with a screw driver note how the washers come off of the front and rear of old spool. Then assembly the washers the same way back onto the new spool. Feed the new line through the front cover. Screw the spinner head back on then the front cover. Tie on a new clip and weight.

 

EZ Hang Inc.

3861 Mount Olive Church road

Moravian Falls, NC 28654

info@ni4l.com

 



Sign up to our newsletter